Plastimo Bilge Pumps
Pump 925C & 1038C: Compact with Integrated Handle
Compact
•The
Plastimo pump is very compact and the 90° position of the outlets
allows installation where space is limited or access difficult.
•Outlets
swivel through 360° and therefore adapt perfectly to the pump position
in relation to the strainer and thru-hull fitting.
Optimum safety
•
No hassle looking for the handle at the critical moment: the Plastimo
bilge pump is always ready-to-pump, thanks to its fully integrated
handle.
• In case the diaphragm would leak, the water is rejected
in the cockpit (not in the bilge), so you can't help noticing it
immediately.
Simple installation and maintenance
• Installing the pump is extremely simple: all done from the cockpit.
•
The diaphragm can be removed within seconds; no need to take down the
whole pump. This facilitates the cleaning of the pump body (remove
small stones and other possible objects clogged in the pump) and
enables the replacement of the diaphragm if necessary.
• Construction from materials impervious to UV-rays.
Design
•
One obviously expects from a pump that it should first and foremost be
efficient... In addition to the remarkable technical performance,
Plastimo has paid a particular attention to design and aesthetics,
building on years of expertise in composite materials and plastic
engineering. The result is a stylishly designed pump, which matches
very nicely the cockpit of modern boats.
Available in 25mm and 38mm hose-connector sizes (1"" or 1 1/2"), at 40 L and 45 L / minute capacity.
Pump 925 and 1038: with Telescopic Handle and By-Pass
Bilge pump with integrated telescopic handle, for efficient and more comfortable pumping.
Supplied with By-Pass, to allow the connection of both a hand pump and an electric centrifugal on a single water circuit.*
* Not suitable for a diaphragm or a flexible impeller electric pump.
Available in 25mm and 38mm hose-connector sizes (1"" or 1 1/2"), at 40 L and 45 L / minute capacity.
By-Pass Bilge Pump Connector
The
By-Pass adapts on pumps 925C and 1038C and allows the connection of
both a hand pump and an electric centrifugal* pump on a single water
circuit.
*not suitable for a diaphragm or a flexible impeller electric pump.
•Simplified installation: the single circuit common to both pumps is a major time/ labour saving asset for boatbuilders.
•Easy connection: straight/elbow fittings with O-rings snap-in easily.
•Minimal maintenance: fittings snap off easily to remove debris or replace valves if necessary.
Outlet with Non-Return Valve
Prevents
backflow into the bilges: mounted as close as possible to the
strainer, the non-return valve locks up the water in the hose.
• Straight outlet for hose Ø 25 or 38 mm: simply sawing off the Ø 25 outlet
• Polyamide valve + nitrile gasket, fuel resistant.
•
Bellows-type gasket allows debris such as seaweed or small cloth. Can
be replaced by a flat gasket. converts the valve in a Ø 38 mm fitting
(a pre-moulded groove indicates where to cut).
For a full and detailed list of Plastimo products available from Storm Force Marine in Hong Kong, please see the Plastimo website.